Installation And Adjustment Of Oil Press Machine

1.Installation

(1)This machine should be fastened to the ground with ground bolts M14. In order to adjust the degree of tightness of V-belt, electric motor should be fastened on the guide-way so that the motor can not move. The length of V-belt should be longer than 3000mm. 

(2)Installing electrical equipment, the current meter should be installed near the oil miller so as to facilitate the operator to observe the current casually.

2.Adjustment

(1)In normal production, use the dull cookie pieces to mill and preheat the machine before pressing(do it as milling).until the surface of pressing cage is hot. Put the pretreated oil materials into feeder then start pressing. The feeding of materials should not be too hard, otherwise the chamber is easy to jam and bear no oil. With the rise of temperature in the chamber, the inserting of materials can be increased progressively.

(2)Turn and adjust the screw, slowly reduce the thickness of cookies

(3)After the oil miller is running normally, select the broken cookies that were first milled with rather rich oil and every mix them into the oil materials to be broiled, baked and milled again.